Medidores de Energía Acuvim IIR
Dispositivos Compatibles
| Device Type | Modbus TCP (Ethernet) | RS485 |
|---|---|---|
| Medidor de Energía Acuvim IIR | ✅ | ✅ |
| Medidor de Energía Acuvim 3 |
Conexión
Ethernet
Para un cableado ethernet correcto: Siga las directrices para el cableado ethernet.
Si tiene un medidor de energía accuenergy, debería tener una interfaz para gestionarlo, en esta interfaz vaya a la página Settings, luego seleccione el menú Communications.
Luego desplácese hasta encontrar estos campos:
Advertencia
Advertencia
Asegúrese de que el puerto esté configurado en 502 y que el Modo de Lectura Rápida esté habilitado y establecido en 100ms Fast Read.
RS485
Info
RS485 Wiring
- For correct RS485 wiring: Follow the guidelines for RS485 wiring.
- If the wiring shown in the table below is incorrect, please let us know.
- There is no general consensus in the industry about the usage of A and B for the RS485 polarity, so it may be counterintuitive and opposite of what you might expect for some devices.
| Device | SmartgridOne Controller model OM1 | SmartgridOne Controller model IG8 | RS485-USB converter | RS485-Ethernet converter |
|---|---|---|---|---|
| RS485 A | RS485_POS | RS485 A | TX+ | |
| RS485 B | RS485_NEG | RS485 B | TX- | |
| RS GND | GND | Not available | G |
Advertencia
NOTE: RS485 Device Addresses
- You MUST give each device on the RS485 bus a unique address. Check the manual of the device on how to do this.
- Use lower addresses first (1, 2, ...) because the SmartgridOne Controller will find them faster!
- For each device, it is generally recommended to stick with the factory default baud rate, parity, and stop bits. The SmartgridOne Controller will scan on those first.
Last updated February 18, 2026Edit this page